Conform to GJB598A-96 standard. With reference to the American MIL-C-26482 standards. They are equailvant to JY series, YB series and MS series, MS series. They can cooperate in use with the receptacles which have the same type. This series connectors are quick coupled by bayonets. Their contacts are soldered. They have merits such as little volume, high density, good resistance to the environment, good reliability and so on advantages. They are widely used in aviation, aerospace, navigation, wild communication, and the electric lines’ connections of electronic equipments such as the managing system of mail and railroad.

Electrical characteristics   a?Working current Contacts code With a diameter pin (mm) section of the wire(mm2) Contacts with the corresponding wires (AWG) Wire diameters (mm) Working current(A) Minimum Largest 20 F1 0.20 24 1.02 2.11 3 0.30 22 5 0.50 20 7.5 16 F1.6 0.50 20 1.35 2.63 7.5 0.80 18 10 1.25 16 13               b? Voltage (AC RMS) and the contact resistance height use level use level? sea level 600 V 1000 V 21336 300 V 450 V Contacts code Contact resistance 20 =5mO 16 =3mO c?Voltage resistance(AC RMS) height high and low experiment pressure use level? use level? sea level 600V 600V 21336 300V 300V d?Insulation resistance Minimum insulation resistance Normal (25?) 3000 MO High temperature (125?) 500MO Humid 20MO

1,when the corresponding 2 parts of the connectors connect by within bayonets, rotate bayonet cap to the right direction. When inserting safely, and bayonet in the place of the connecting is locking, a white bayonet pin can be seen through the observation hole on the circle of the connecting bayonet cap. 2, wires of the connector should be corresponding to the contact NO., welding time can not exceed three seconds (electric iron shall not exceed 45W). 3, welding-type connector after welding, the plywood or the wire-protecting covering of the electric coat should nip tightly. 4,When 2 parts of the connector have to insert for a long-term (such as storage and use), the safety hole on the connector will be wire linked and nipped tightly with the receptacle. 5, After separation of the two parts of the connectors, the two parts have to cover a dirty-Shield (or to be plugged to a empty receptacle.) 6, no inserting of the pin with receptacle. 7, connector installation, the use of staff should understand performance and usage of the connector. Before un-tightly locking, prohibits using, when there is electric charge, prohibit the separation.   cooperating relations between plugs and sockets  A, when plug and receptacle couple with each other, if plugs install pins receptacles should install holes, the same to the opposite. B, plug and receptacle should have to choose a shell with same oil painting on its surface, precedent choosing color is black, army green or nickel plating. Stored  Connector storage for eight years, and years before they went into the assembly calculation.